Siding Contractor in Pflugerville, TX Built for Hail, Heat & Clay Soil

Impact damage from spring hailstorms. On vinyl it shows up as punctures, cracks and broken panels. On fiber cement you'll see chipped edges and corners and stripped paint. On aluminum it's dents. Damaged panels let wind-driven rain reach the house wrap and sheathing.

The Williamson–Travis corridor gets frequent hail between March and June, often 1–2 inches or larger with straight-line winds behind it. A single storm can hit an entire subdivision, so dozens of homes in Avalon or Highland Park file claims the same week. Vinyl that's been baked brittle by years of UV breaks more easily, and so does vinyl that's cold. Insurers often push back on matching when only some elevations are damaged, which leaves homeowners with mismatched walls unless the damage is documented carefully.

• Holes or spiderweb cracks in vinyl panels
• Chipped corners and exposed gray fiber cement
• Paint stripped on the side that faced the storm
• Dented aluminum trim, gutters or downspouts
• Panel fragments in flower beds after a storm
• Neighbors with adjuster visits or roofing signs

Damage is usually heaviest on west and north walls, the directions spring storms come from. Newer subdivisions east of I-35 near SH-130, including Avalon, Sorento and ShadowGlen in Manor, often see clusters of claims, along with out-of-town storm chasers knocking on doors.

We document the damage with photos and measurements for your insurer, then replace the broken panels with matched profiles. Where matching isn't possible, we replace full elevations using impact-resistant products.

This is failure of Masonite or LP-type pressed-wood siding. Once moisture gets past the paint, the boards swell at the bottom edges, go soft, delaminate and grow mold. The sheathing behind them often rots too.

Homes built in the 1980s and 1990s in Windermere, Springbrook and Wells Branch used hardboard on the sides, backs and gables. Thirty to forty years of Pflugerville humidity, heavy downpours and sprinklers hitting the walls have broken down the wax binders. Hardboard wicks water at the ground line and roof line, and summer humidity keeps it from drying out. Woodpeckers go after the soft spots because the boards are full of insects, and every hole lets in more water.

• Swollen, flared or mushroomed bottom edges
• Boards that feel soft when pressed
• Paint peeling in strips or blistering
• Woodpecker holes in gables
• Dark staining near the ground or along roof lines
• Visible fiber texture where paint has failed

We see it most on the rear and side walls of brick-front homes in Windermere, Wells Branch and older parts of Round Rock like Fern Bluff. It's usually worst near sprinkler heads, under gutter-less eaves and on low walls next to patios.

We remove the hardboard, inspect the sheathing and replace any rot. Then we install new house wrap and flashing and finish with fiber cement such as James Hardie, painted to HOA-approved colors.

A kick-out flashing is a small diverter where a roof edge ends against a sidewall. Without one, roof runoff pours behind the siding, soaking sheathing and framing inside the wall where you can't see it.

Production builders during the 2000s and 2010s boom often skipped kick-outs or put them in wrong. Pflugerville's rain tends to come in heavy bursts, so a single spring storm can send gallons of water into one spot. Humid summers keep that wet wood from drying, so rot and mold grow for years before anything shows on the outside. Many homes in Falcon Pointe, Blackhawk and Villages of Hidden Lake have the complex rooflines where this happens most.

• Streaks or stains below a roof-to-wall corner
• Soft siding or trim under an eave intersection
• Musty smell in an adjacent room
• Drywall stains or bubbling paint inside
• Swollen window trim below a roof line
• Mold at baseboards on exterior walls

It turns up on two-story homes with garage roofs meeting second-story walls, which is very common in Falcon Pointe, Blackhawk, Teravista and Star Ranch. Damage often shows up 10–15 years after the house was built, about the time owners first repaint.

We open the wall, assess how far the rot goes and replace the damaged sheathing. We install proper kick-out and step flashing, then re-side and seal the area.

These are gaps at fiber cement butt joints, corners and trim, and separations where siding meets brick. They happen when expansive clay moves the foundation and racks the wall framing above it.

Houston Black clay swells after heavy rain and shrinks hard in droughts like 2022 and 2023. Every cycle flexes the framing. Rigid caulk joints that builders put in tear apart, butt joints spread and trim pulls loose. Homeowners often can't tell if it's a siding problem or a foundation problem. We look at the pattern of the damage to help sort that out before anyone spends money on the wrong fix.

• Gaps at butt joints you can see daylight through
• Caulk pulled away from trim and corners
• Stair-step cracks in adjacent brick veneer
• Windows or doors sticking or out of square
• Trim boards bowing away from the wall
• Gaps that open in summer and close in spring

It's common across Pflugerville, Hutto and Manor, where clay soils dominate. Look for it at corners near downspouts, at brick-to-siding transitions on front elevations, and on homes with uneven watering or big trees near the foundation.

We re-detail the joints with proper gaps, flashing and flexible high-performance sealant, then reset loose trim. If the pattern points to the foundation, we'll tell you to get an evaluation.

This is sun damage. Colors fade, factory paint chalks on fiber cement, and vinyl panels warp, buckle or oil-can when they can't expand freely in heat.

West- and south-facing walls in Pflugerville take hours of intense afternoon sun through long summers that regularly reach 100°F. Builder-grade paint on 10–20-year-old fiber cement is chalking across many 2000s subdivisions. Vinyl that was nailed too tight can't move, so it ripples. Reflected heat from neighbors' low-E windows on tightly spaced lots can make the warping worse.

• Chalky residue that rubs off on your hand
• Noticeably lighter color on west walls
• Wavy or rippled vinyl panels
• Panels that have slipped out of J-channel
• Brittle, cracked caulk lines
• Faded shutters and trim

Very common in Sorento, Highland Park and Blackhawk homes now 10–20 years old, and on vinyl-sided homes in Manor and Hutto. The back walls facing west over open fields and greenbelts tend to fade first.

We replace warped vinyl with correctly fastened panels. For fiber cement, we recommend pre-finished or properly coated replacement boards, or refreshing the trim, in heat-tolerant HOA-approved colors.

This is decay in wood window sills, corner boards, fascia boards and soffits. Rot lets water into the roof edge and walls, and it gives squirrels, rats and wasps a way into the attic.

A lot of homes in the area combine fiber cement siding with finger-jointed wood or hardboard trim. Paint on that trim fails fast under Central Texas UV. Overflowing gutters during heavy downpours soak fascia, and humid summers keep it wet. Window sills catch water every time it rains.

• Soft or crumbling fascia behind gutters
• Peeling paint on window sills
• Sagging or gapped soffit panels
• Animal droppings or nests near eaves
• Gutters pulling away from the roof edge
• Black staining at trim joints

Fascia rot is widespread on 1990s Wells Branch and Brushy Creek homes. Sill and trim rot shows up on window-heavy rear elevations in Falcon Pointe and Teravista. Old Town homes often have original wood trim with lead-based paint.

We replace rotted wood with fiber cement or PVC trim and install vented soffit. Fascia gets primed and sealed properly, and pre-1978 homes are handled with lead-safe practices.

This is leakage where siding meets windows, doors and penetrations. It's usually caused by missing head flashing, reversed laps in the house wrap or J-channels that dump water behind the siding.

Heavy spring and fall downpours with gusty prairie winds drive rain sideways into every weak detail. Foundation movement pulls window openings out of square, and the seals break. Quick builds and quick repairs often left out sill pans or lapped the wrap the wrong way.

• Stains under window corners inside
• Swollen or soft trim around windows
• Peeling interior paint below sills
• Water in the window track after storms
• Mold smell in bedrooms on exposed walls

Most often on north and west walls facing storms, on two-story gables in Villages of Hidden Lake, and on vinyl-sided homes in ShadowGlen and Star Ranch where J-channels weren't finished correctly.

We remove the siding around the opening, repair the damaged sheathing, and install sill pans, head flashing and properly lapped wrap before reinstalling or replacing the siding.